PDA

View Full Version : rear bearings


twgranger
11-15-2003, 09:34 PM
to put new rear bearings in a tri-z do they have to be pressed in?
TRI-Zbrian
11-15-2003, 09:46 PM
they dont it will be a tight fit but you can get them in your self try taking a flat piece of would and puting it up against the barring wile it is ready to go in and tap on it with a hammer. worked when i redid a 200x. just be carful the barring goes in straight
Darius1502
11-17-2003, 04:00 AM
the swinger bearings you can do yourself...just be careful. You should try using a sock and hammer. The right size socket (one that fits just around the edge of the bearing and bushing housing and a hammer will work great. Be really careful to get the bushing in straight...it should move freely.

As far as the rear end bearings..I had those removed and replaced by a shop. It was too much for me.

Best of luck!