Any aftermarket skid plates besides PRM?

[Matrix]

The 86' 200x rear skid plate was on it's last leg for a while then when I landed on a stump it finally died. Sooo, I'll need a new one but the only one's I found aftermarket were PRM and I would really rather not spend $110.00 on a SKID PLATE... So does anyone know where to get one that isnt expensive as hell? Even though the PRM one is expensive it looks like it will never go bad.

[Dirtcrasher]

Depends where you ride I guess. I love knowing I have a .250 PRM back there and new mounts I made. I can nail any boulder I wish :D

Cost means nothing when you can bend something else; The stock mounts are terrible.....

Tapper can make one you can fit on there with a few skills, a bit thinner but probably allot cheaper.

[deathman53]

here is the one I have....DG 58-2016 atc350x/86-87atx200x swingarm skid 89.95. this was bought in 05