tri-z rings

[slaughter]

so i need a set of rings but its kinda hard to find the right ones and wanted to know will any other rings fit or can i use the wiseco with the stock piston

[Just-Tri-It]

Seem I read a post on this subject and it wasn't recommended to mix the two. Might do a search but it will take a little time to read through the search finds.

[bcredneck]

wisco and stock rings are almost always different some times there are even more of them i fixed a cr 125 with a wiseco piston that had two rings and we bought stock rings and there was only one ring and it wouldnt fit in the grove

[slaughter]

yea i tried searching for it cuz i do remember seeing something like that a wile ago but came up short so was hoping that some one could just give me a quick answer
but i did find some on ebay and hopefully these are the right ones http://www.ebay.com/itm/180441512997?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649#ht_500wt_1180

[badass350x]

No you can not switch rings between the two pistons. Do you know what piston you have? Size of piston?

[slaughter]

as far as i know its all stock but im not really sure how to tell the diff

[Yamaha_Rules69]

Measure the piston with a caliper at minimum to tell what size it is. You can use a regular US standard caliper, if its not digital or mm, divide the number in inches by .03937 and you will get the piston size in mm's. I believe you can use Sudco or ART rings on a stock piston, as both the stock piston and the two listed are cast pistons, where as wiseco is forged. Good luck!