Honda Fork question

[Big Mike]

I searched and could not come up with an answer. What am I looking for is an answer to wether or not, there is any interchangability between fork tube caps on any other Honda forks to a 350x? I have 2 sets of forks, both of which dont have the best caps on them and in fact one of mine is actually leaking I noticed this weekend, so I need to find replacements for these and to find them on Ebay is difficult and obviously they are long since discontinued by Honda, but there is quite a few still available for the 250R, and wanted to know if they would work for my 350x or not. So if any of the Honda gurus on here could answer this question for me, I would be very appreciative. Thank you.

[grtrat1]

Not sure about the 350x, but my 200x has O-rings on the caps.. You may just have to replace those..

[Big Mike]

Well physical condition is not good on these, and the bleeding is coming out of the schrader valve, and tightening it up did not stop it.

[willreed03]

You can replace just the schrader valve as well. And while I never swapped the caps between the 250R and the 350X, I am fairly certain they are the same thread. The design may be slightly different but I believe they would work.

[Dirtcrasher]

Change the schrader, clean out the cap......

83/84 250R may fit as they are also 35MM forks.

[Big Mike]

Thats what I was thinking too Steve. Thanks man.