I need Help!!

[Auto_Demon]

k so my trike has been sitting for about 2 months cuz i was waiting for my axle bearings and they finally came in so i put them in and i went fo a ride and when i was out there i stopped to check on things and i saw my carburetor leaking alot of gas so i shut it off and i waited for a bit then i quckly rode home. so i took the carb apart and adjusted the floats put it back together and it still leaks, so i did it again and now its not getting any gas! so i reffered to my manual and it said that the floats need to be 20mm from the base of the carb without touching the needle so i did this and it still leaks gas!!! please i need help asap:wondering

[59GMC]

u must have screwed somthing up when u took the carb apart cz trailprotrailpro an idot and shouldent mess with things if u dont know what u r doin. jk, haha

[jordan_muirhead]

leaking out the bottom?

[Auto_Demon]

u must have screwed somthing up when u took the carb apart cz trailprotrailpro an idot and shouldent mess with things if u dont know what u r doin. jk, haha

no i took it apart right, it never did this when i stopped riding it

[Auto_Demon]

leaking out the bottom?

ya its leaking out of 2 places , one out the back of the carb and a tube coming out the side

[jordan_muirhead]

did you hook the fuel line on top...or on the side?

[just ben]

chances are something is holding up the inlet valve. doesnt take much clean the needle and seat set the float to spec and ride

[badass350x]

yep needle and seat needs cleaned or replaced. its not shutting your gas off when the float rises.

[Auto_Demon]

we fixed the problem some how, butg thanks for the help guys