250r billet exhaust flange "orings"?

[3wheelrider]

Can anyone tell me where to get replacement high temp orings for the billet flanges? And what size are they?- 49mm? 50mm? 51mm? ..............I hope they all use the same size.:wondering

[falloutboy]

i'm pretty sure fmf sells a kit that has the o-rings and springs...

[3wheelrider]

Alright ...but I dont want to pay for springs (mine are new OEM)- just need the orings. I cant find 'em alone. And not positive on the size.

[250rRoostmaster]

I use these gasket and they work amazingly good, much better than the o-ring style. No leaking at all.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=160522500936&viewitem=&sspagename=STRK%3AMEWNX%3AIT

[250rRoostmaster]

You just gotta make sure that when you put them in you take your time, you have to lay it in the groove then tap it with a hammer to get it seated properly but when done you will be impressed with the results and the guy gives you a exhaust flange gasket to boot!!

[3wheelrider]

I use these gasket and they work amazingly good, much better than the o-ring style. No leaking at all.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=160522500936&viewitem=&sspagename=STRK%3AMEWNX%3AIT

Hmm.. never seen that. Is it real sticky?(to aid in installation). It does seem a little troublesome tho to make it work.

[250rRoostmaster]

Yes it's sticky and it does take a bit more effort than o-rings but it's not hard by any means and it's a far better seal and works much better... You wont get leaks with this style!!