finally finished my 84 200x

[pcs]

so i finally managed to finish putting together my 200x, to many other projects so its been a slow process. my main goal was just to get it running then start the small odds and ends on it. im still taking it easy on the new engine and i need to swap out the stock carb for a 28 mikuni i have that is ready to go.

[250rRoostmaster]

Nice X man!!

[hoosierlogger]

looks good, how do you like the higher compression piston? The stock one I got from you is alive and well in my 84 200x. Better get a grab bar on there to save your rear plastic.

[pcs]

i do need a rear grab bar, im going to make one at a friends fab shop out of some thick alum. im waiting on getting material bc i took of the l.e.d. light bar off my suzuki and im going to put it on my atc, its a 8" square type from rigid industies, but need to figure out how im going to mount it first. its very bright! the piston is a 10.25 c/r and it is a tough cookie to kick for its little size. i can kick over my friends 250r atc and lt250r much easier but its still easier to start than a lt 500r =)

[pcs]

here is the pic of the light on my ltr that im going to mount somewhere by the handle bars or between the fork clamps