Tecate carb pics for Chuck

[jeswinehart]

Chuck, I found the 2nd. boot I made (3 years old) that I run a 36mm carb in since I made it and it did indeed take a set for the 36mm carb.
Not as sloppy as a 36mm boot like the 86/87 Tecate four wheeler but certainly not snug either (but usable for 32mm (84 modle) or the 34mm (85 modle)124630124631124632
Well, I found out what I wanted too so perhaps you can glean some info from my pictures.
It is quite possible you have a intake from the 86/87 Tecate 3 wheeler which if I am not mistaken is a 36mm stock carb.
How you can tell is the 86/87 intake boots have 2 little protrusions sticking out and the top that another protrusion on the carb fits in between.

[coyoteklr]

Ok that helps alot. the carb in the right picture looks to be the exact carb I just bought. Here is a question for you.. in that picture you measure about 34mm. why is that measurement so much smaller than the stock carbs? In both stock carbs I have, they measure 38 mm right there. and around 44 mm outside diameter. It seems to me there is no way that carb could fit in a stock boot. I just dont see it possible. I know my dads 84 is a stock boot because he is the origional owner, its the same as my 85. I mean its not just a little sloppy its not even close. If the bike was at my house i would post a pick, but its not.

[coyoteklr]

Also how would I attach the throttle cable to the new carb since the cap doesnt have an elbow?