long time no post got a 3 wheeler again

[acidburn]

so i just bought a 185s 3 wheeler and im ordering a new chain adjuster cause the one on my bike was missing:wondering no i was reading around here and IN MY MANUAL yes i checked the manual first but its not very clear all it says is


check chain for free play, if too much loosen the four rear wheel bearing holder bolts, turn the adjusting nut as required untill free play is correct

so where do i find these 4 bolts :drool: i see 1 big bolt on each side one on my adjuster side and one on my brake drum side is it these bolts :S i dont want to snap another tensioner lol

[RubberSalt]

If it's anything like my 200m, and im sure it is, then it's the 4 bolts that hold the axel on. the 2 lower bolts should be slotted to move back and forth, while the top bolts are what it pivots on. In the middle of it all, there should be a chain adjusted, a little nut on what looks to be some all thread coming on the back on the right side of the chain.

All this is done right in the middle of the bike above the rear axel. Once the 4 bolts are lose, you can use that nut to adjust how tight the chain is. Rocking the bike back and forth helps alot.

THIS ONLY TRUE IF IT LIKE MY 200M!

[acidburn]

is trailprotrailpro 200m a hardtail rubber err i cant put a quetion mark cause of my french keyboard ÉÉÉÉ thats what question marks look like when i try them on here

[RubberSalt]

Yup, they are hard tails... REALLY HARD damn i want suspension lol

[acidburn]

wow i feel like a noob now lol..
http://img17.imageshack.us/img17/6725/bearingholder.th.png (http://img17.imageshack.us/i/bearingholder.png/)

Uploaded with ImageShack.us (http://imageshack.us)
i just didnt see the one bolt and the tensioner bolt makes it 4 LOL thank god i found the shop manual on here alot better then the plain manual

[RubberSalt]

We all feel like noobs at times.. Like when i bent the 2 valves trying to set the valve timing on my klt lol

[acidburn]

:P i once tried to time my 3 wheeler knowing nothing about engines getting instructions over a phone LOL turns out i had it timed but 1 tooth off! lol