Ugh 14mm rod end but 15mm wrist pin!

[Xowner]

Lame ended up with a stroker crank with 14mm rod end and a 15mm wrist pin piston!!! What do i need to look for to make sure i get a 14mm wrist pin?

Thanks

[barrett8]

atc 90s use the 14mm wrist pin and the 110 uses the 15mm wrist pin

[swifty]

ive got a +3mm non dome kit and a +5mm dome rocky kit $75 each if you need one both 14mm pin

[big specht]

Just ream the the rod out to fit the pin

[shortline10]

Pistons 14mm & 15mm have different deck heights , wont work .



Just ream the the rod out to fit the pin

[big specht]

change the base gasket to make up the differance. Thats how I did mine on my old atc 70 build using a atc 90 piston on a 70 rod I just reamed it out to 14mm .

[shortline10]

Thats a-lot of gaskets to make up the difference LOL



change the base gasket to make up the differance. Thats how I did mine on my old atc 70 build using a atc 90 piston on a 70 rod I just reamed it out to 14mm .

[leevarnado]

i read something awhile back where you had to shave the top of the piston for correct deck height,i believe there might be something in this link about it.

http://vincentcrabtree.co.uk/XR200.aspx

[greenhuman]

Install an early 110 rod in the crank and make up the difference with a spacer plate.
What size stroker?