ATC185R
02-28-2011, 02:38 PM
Found dimensional software online for the expansion chamber, cut out templates out of cardboard, transfered to 16 gauge, cut out with plasma torch, seam welded with MIG, welded a hydraulic fitting into end and welded other end shut, connected hydraulic hose to fitting and into hydraulic remote on JD 7710 tractor, feathered remote lever to regulate oil flow and puffed it up like a balloon. Cutt off fitting and welded on correct diameter and length of stinger, made one cut and seam weld in front section of pipe to change angle, made support bracket to foot peg, and there you go. DRAG PIPE. And yes it is ported for the pipe by eric gorr and it is jetted perfectly. Little booger screams now!