PDA

View Full Version : 84 200x mods?



shark
01-20-2011, 05:28 PM
I going to start out slow on the upgrades for my ride. First i'm going to go through everything, fluids, cables, carb, lube. What kind of air filter do a want to get? Also I could use some rear tires if anyone has any recommendations.

shortbus
01-20-2011, 08:48 PM
Thats a clean trike, you could get a uni filter, jet kit, and a pipe, and maybe some razrs for the rear.

shark
01-20-2011, 09:15 PM
Thats a clean trike, you could get a unifilter, jet kit, and a pipe, and maybe some razrs for the rear.

You need a jet kit to go with the pipe, correct? What type of perfomance will I gain from that.

oscarmayer
01-20-2011, 11:05 PM
about 1-1.5hp and on that small engine that's a lot. before you do any performacne mods, you need to ensure the bike is able to handle it. change all fluids, check the rear swingarm for warn bearings, check the front and rear axels for bad bearings as well. ensure everythign is nice and tight. next do a compression test to see where the cyclinder is at. if it's too low, time to rebuild the top end.

speaking of top ends, go ahead and check the valves and ensure they are correct.

after all that, then look at performance.

shark
01-21-2011, 06:30 AM
Thats good advice. I'll check that stuff out. I'm going to have to wait till it gets a little warmer, not everyone lives in Texas. The wind chill is below 0 in Michigan right now.