PDA

View Full Version : Swingarm bearing question


camoweasel
11-21-2010, 02:23 PM
On my 350x, I have my SW off right now sanding it and repainting it. With sw bolt, nut, washers, and dust seals off, there is some play with that hollow shaft that goes through the SW on one side. Is that an indication that bearings are wearing?
Dirtcrasher
11-21-2010, 03:29 PM
Yep, get an All Balls kit for it............
camoweasel
11-21-2010, 04:45 PM
52 bucks for the bearings, seals, caps, and shaft; not bad at all! Thanks Dirtcrasher. Now the trick is getting the old ones out. After ruining 2 sockets, I think I'm going to take it to a machine shop to have them pressed out. Thats only if there's enough meat left on them due to my relentless beatings.