0.80 over Tri-Z - now what?

[tom oneil]

Having my '86 Tri-Z bored to 0.80 over and looking down the road. Since it's not on a Trike I thought about selling it unless I can get a line on a decent builder to do the whole motor next time around. It has to need a rod & bearings by then.

Any good builders out there? Any interest in an 0.80 over '86 that runs?

[Tri-Z 250]

You should have no problem selling the top or bottom even after you run this pistons life out. I'm susprised your bottom crank is good but not shocked. As long as the 6speed trans is in running order...depending on your value of it depends on how fast it will sell. We have Wiesco in our backyard and a few of the machine shops in the area will resleve the head good as new. I was confused by the motors not on a trike?...Just out of it, or being used for another machine? If you want to sell it off I'm always interested in 86'Z complete motors bown tops no problem PM me.

[tom oneil]

It's on an Outlaw Wing Kart right now - http://www.youtube.com/watch?v=2JV6pEhwSbU - these are 500's but the Tri-Z will outrun most 250's and give the 500 karts hell.
Mines a 5 speed - does that make it an '85 ?

[tommerp]

Niiiice That thing must haul!! - Yes it's an 85 with a 5 speed.

[Tri-Z 250]

^^ yep 85' or 85.5' still of value...just not as much as the 6speed

[Eric250R]

We can rebuild it for you....just ship it on over.