Yamaha 200e centrifugal clutch will not come off, any ideas?

[takeuchitb007]

I've been fighting with this thing for 2 hours trying to get it off and it wont budge.. I got the nut to loosen without much trouble but now I can't slide the primary clutch off at all, it wont move.. DId they put locktite on the splines from factory? ANybody ever see this before? Any ideas ???? :confused:

[MonroeMike]

Do you have the notch lined up on the secondary clutch to remove it?

Page 135, figure 11.

http://72.52.143.80/~trikes/ytm200&225-fm200_clymer_manual.pdf

[takeuchitb007]

oh yes I had the notch in the secondary clutch drum lined up right.. I ended up getting it out using a puller and tapping the primary clutch drum with an aluminum drift.. Some genius had put locktite on the splines of the shaft :rolleyes:
I knew something wasn't right, these things aren't supposed to be that difficult to remove.. The primary drum and clutch shoes are grooved real good so I doubt i'll be using it, I have to try and find a decent one I guess..