motor hop ups

[mooseman1616]

I pulled the motor out of the bike and was wondering, while it's getting rebuilt what kind of hop ups should I do? What are the common ones on this engine? Is it even worth it? Thanks.

[shortline10]

For a rider I would go with a mild cam , Wiseco piston , preformance exhaust and a uni filter . Will be reliable with these mods and really wake it up . Oh an dont forget to put new clutch plates after all the mods it will need it .

[Mr_RPM]

what machine is this for?
shortline said it, but don't forget. when getting that piston get one with a bit higher compression. anywhere from 10:1 to 11:1 will be a good hop up and still be reliable and most likely still run great on pump gas (premium)

[mooseman1616]

thanks that's pretty much what I thought, but just didn't know if there is anything I was missing

[bigredneckrider]

Where is a good place to get a piston and a mild cam for a 200 ? I seen a 65mm hi compression piston on ebay the boosts up to 12-1. is that too much? i dont know the factory comp ratio.

[Mr_RPM]

12:1 is quite high but to me its not to much. you might need to run race gas (100 to 110 octane) what machine is this? (year and model) my big red 200es is like 8.1:1 or something......stock is normally 8-10:1 ish. some where in between. atleast for most of the 200cc honda trikes.

[mooseman1616]

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=140474120924&crlp=1_263602_304642&ff4=263602_304642&viewitem=&guid=22996c471280a0b5834267e2fffca87d&rvr_id=165618269877&ua=WXI7&itemid=140474120924

Do you think that this kit would be good or should I stick with Wiseco?

Also I have been looking everywhere for a mild cam and can't find one, any links would be appreciated. Thanks

[shortline10]

That piston kit is a lower compression kit and isnt an upgrade at all . You will be happier with a wiseco. Look here for some cams .
http://www.megacyclecams.com/
http://www.powroll.com/P_HONDA_ATC200X.htm
http://www.webcamshafts.com/
And here is an inexpensive one
http://cgi.ebay.com/ebaymotors/83-85-ATC200X-Camshaft-Hi-Performance-Cam-ATC-200X-_W0QQcmdZViewItemQQhashZitem43a26c62d5QQitemZ29048 7821013QQptZMotorsQ5fATVQ5fPartsQ5fAccessories



http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=140474120924&crlp=1_263602_304642&ff4=263602_304642&viewitem=&guid=22996c471280a0b5834267e2fffca87d&rvr_id=165618269877&ua=WXI7&itemid=140474120924

Do you think that this kit would be good or should I stick with Wiseco?

Also I have been looking everywhere for a mild cam and can't find one, any links would be appreciated. Thanks

[mooseman1616]

thanks...so can I run parts for a 200x on a 200m?

[shortline10]

Yes you can .


thanks...so can I run parts for a 200x on a 200m?