This may be a dumb a question......But....

[Shorty]

Will this big bore XR500 sleeve bore into a 350x jug? http://cgi.ebay.com/ebaymotors/Honda-XR500-XL500-CYLINDER-BIG-BORE-SLEEVE-1978-82-_W0QQcmdZViewItemQQitemZ130373479927QQptZMotorcycl esQ5fPartsQ5fAccessories#ht_556wt_686 I know a stock xr500 sleeve will fit nice and snuggly at 89mm's . But a big bore 500 jug?? I have no idea. lol.

[Dirtcrasher]

In think it's an XL jug that fits but you still have to bore the cases........

[SWIGIN]

I highy doubt that will fit. See my ascot head thread and see how close a standard 500 sleeve is to being too big.

[Shorty]

Ok did a little more research and found this thread.............http://www.3wheeler.org/vb/showthread.php?t=15209.............and it says the max bore you can get out of a 350x motor is 95mm.....So I guess that means I can use this sleeve?? I still have no clue..lol.