atc 70 flywheel removal need help

[m brater]

I broke down and bought a puller and it done what it should. Now I can't get the flywheel all the way off! The puller pushed it to the end of the shaft but now the puller end is too big for the whole in the flywheel. Is the puller saposed to go through the flywheel whole?

[m brater]

A little help would be nice. Why won't this flywheel come off?

[louk]

u have the puller threaded into flywheel then center puller bolt pushes on crankshaft end once i get it kind of tight i smack puller center bolt with hammer and the impact pops flywheel off crank send a pic of your flywheel tool as u have it on the flywheel

[m brater]

Thanks for the reply louk. I did finally get it off. Magniteo is grooved pretty bad from the stator rubbing. Maybe that's why there's no spark as I have new points condenser and coil?

[louk]

did u check your crank bearings or key way something had to move to cause flywheel to dig in to stator