New Plastic

[zeeker1]

Just sprung for some new rear plastic on my 185s. Are there any tricks for drilling all those holes RIGHT the FIRST time? I'm nervous...zeeker

[shortline10]

Just sprung for some new rear plastic on my 185s. Are there any tricks for drilling all those holes RIGHT the FIRST time? I'm nervous...zeeker

Sometimes maier will predrill for ya but if not set the old fenders under the new ones and mark the holes . I always use a unibit so I can go bigger if needed LOL .

[Thorpe]

Make teplates off your old plastic and transpose the holes to the new... (and as mentioned, a unibit helps too) And dont start drinking beer till after you are done.... :beer

[volfan537240]

everything ive ever bought from maier was pre drilled

[zeeker1]

These came from Maier and there's not a hole one drilled......zeeker

[volfan537240]

well that sucks. id measure the top holes and mount it. then drill through the fender brackets into the fenders to make sure they're lined up.

[zeeker1]

Thanks for the tips guys. NO BEER TILL I'M DONE????? Phooey! I can drill holes in the wrong places stone sober thank you.

[haggard 2hundie]

my maier front fender came un drilled i started with small holes after i marked it out with a sharpie and the old fender

[bobotech]

Just use a 2 inch hole saw and your hole will be PLENTY big enough!

[volfan537240]

and some big washers lmao!

[Mr_RPM]

anyone have some pics of drilling process? or some finished pics?

[motoman1012002]

how did it come out

[thestud25]

Just use a 2 inch hole saw and your hole will be PLENTY big enough!

I literally laughed out loud!