350 x valves

[poacher]

i need to know what to adjust my valves to in my honda 350x i have feeler gauges just dont know what i need to adjust them at thanks

[NOS_350X]

take off your gas tank. and you will see the valve covers right there at the top of the engine

[Yardbird]

If you're looking for the gap spacing then it is 0.08 mm or 0.003 in. according to the 350X factory service manual. Hope this helps ya.

[jeswinehart]

welcome aboard poacher,,,
you might already know this but just in case you don't,,, you need to have the piston a top dead center (tdc) on the compression stroke b-4 adjusting your valves. when you are at tdc,,, you will be able to "wiggle" both valves. at that time you can proceed to do the adjustments correctly ( and only then ).

john

[poacher]

thanks alot guys now i need to what clip setting i want my needle in the carb ? it has a full exhaust (bigger head pipe)

[jeswinehart]

3rd. clip down from the top is the stock setting.

john