View Full Version : 200s engine break in
PAPA250r
04-19-2010, 10:50 PM
whats a good procedure to break in a rebuild 10:1 honda 200s ? fireing it up tomorow nee dsome tips thanks !
AutoXer
04-20-2010, 03:48 PM
I allways just ride like you normally would .. make sure you vary your throttle and no wot runs to top speed for a few trips then change the oil and you should be good to go
oldskool83
04-20-2010, 03:56 PM
same, im on my 4th hour, gonna ride an hour tonight and then change oil then go at it WOT
shortline10
04-20-2010, 04:01 PM
Depending how tight you had it bored but I always bring the motor up to temperature and let it cool off completly . Do this procedure a few times and your good to go . Also change the oil after about 2/3 hours of running . Also check the oil after a few min of run time , the dry top end will use up some of the oil and it might be a bit low .
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.