View Full Version : 200s question... it just dies??
84atc200
04-11-2010, 10:22 PM
when i peg my 200s wide open quickly it wants to cut out and die...any ideas??
Walkerallen
04-11-2010, 10:32 PM
clean the carb first
84atc200
04-11-2010, 10:35 PM
clean the carb first
ive cleaned it already very well
Walkerallen
04-11-2010, 10:38 PM
was it dipped in a dip tank, or just sprayed with carb cleaner? have you tried to adjust the idle mix screw
84atc200
04-11-2010, 10:50 PM
was it dipped in a dip tank, or just sprayed with carb cleaner? have you tried to adjust the idle mix screw
cleaned it with carb cleaner and a dip tank...as far as the mix screw i havent touched it... i checked the spark plug and it looks fine it wasnt carboned up bad or anything
Walkerallen
04-12-2010, 04:40 PM
did you remove all the screws and bolts when you dipped it. if not you didn't get the carb clean at all. when you take it out of the dip tank, run it under water then blow are through Evey hole and opening with compressed air
84atc200
04-12-2010, 10:43 PM
did you remove all the screws and bolts when you dipped it. if not you didn't get the carb clean at all. when you take it out of the dip tank, run it under water then blow are through Evey hole and opening with compressed air
ive noticed when its warm i sometimes have to choke it to get it to start and gas will shoot out of the overflow tube like its maybe the floats?? like its maybe flooding ...and sometimes i have to turn the gas off and choke and hold the throttle open to get it to start
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.