piston question

[Mr_RPM]

http://cgi.ebay.com/ebaymotors/HONDA-ATC110-COMPLETE-PISTON-KIT_W0QQitemZ220554620681QQcmdZViewItemQQptZMotors _ATV_Parts_Accessories?hash=item335a146f09


ok so i found a 10.5 : 1 compression piston for my 110, but its 4mm bigger than stock, goes from a 52mm to 56mm. this is a huge piston. will i need to re-sleeve or can i just bore to size. what are your idea on this piston, will i need to buy anything with it?

do u guys know of any high compression pistons that arnt so huge? even up to 12:1 compression.
thanks for any info

[Dirtcrasher]

If you were to bore out your cylinder another 4MM, I can't imagine that there would be much wall left if any on the OEM sleeve.....

[Mr_RPM]

yeah thats what im thinking, lol has anyone seen this done before?

[Mr_RPM]

i did some research, i think im going to buy that piston, then buy a used cylinder then bore it to the required 125cc, if it works it works, if not then ill just use my cylinder i have now and look for other high comp pistons. alot of people have done this big bore kit before but it sounds very risky, so ill just do it on a spare cylinder. wish me luck

[200XMichigan]

If you have the cylinder resleeved then it will be reliable too. See what the manufacture says. It should say if its meant to be bored or resleeved.

[shortline10]

It will leave aprox 1mm of cylinder after the 56mm bore and if you dont build a 10,000 rpm race motor it should be fine .