Wiring Woes

[MudBug]

with my beater big red all ready to go, all is left now is to wire it up. I have the harness in place and I hooked up everything I see (there arent ways to mess it up seeing how the big plugs only fit with a certain other one, and the small wires are color matched) and now I am trying to get spark but I cant :wondering I cant check it with a battery charger because the neutral light doesnt have a bulb and electric start doesnt work. Is there any main things that I should look for that would cause no spark? At this point I hope its not a broken wire or something down in the stator. I really dont want to take that motor out again :twisted:

[MudBug]

bump. still couldnt figure it out :wondering

[mopar_man]

Get yourself a wiring diagram, a multi-meter and go to town. Start at the kill switch and go from there.

[Frankencelery]

What I do in these cases is get a wiring diagram and study study study it, until I know where every wire goes. Then, like Mopar Man said, use a multimeter and check continuity between all connectors.

[code200k]

check your grounds too

[harryredtrike]

shouldnt have to pull motor to get to stator,if you end up that route

[MonroeMike]

Wiring diagram.

http://www.3wheelerworld.com/attachment.php?attachmentid=85520&d=1261803431

[MudBug]

thanks guys. my main problem is finding enough time to get in the garage and work on it, ive been busy lately. so when I do get some time in on it ill update this thread