View Full Version : Mad 70 wants some gas!! Update on 3 trikes!
CRAZY70MAN
01-04-2010, 10:07 PM
Well, dropped off hubs to be turned......got the clutch cable, throttle cable, and all fuel lines mounted as well as the tank!:naughty: Got a little engineering goin' on the kickstart....... grind,cut,grind,cut.........at least I can use the kickstart and leave the fenders whole...http://i388.photobucket.com/albums/oo321/andyatc70/th_Picture644.jpg (http://s388.photobucket.com/albums/oo321/andyatc70/?action=view¤t=Picture644.jpg) Lay's flat when riding....http://i388.photobucket.com/albums/oo321/andyatc70/th_Picture645.jpg (http://s388.photobucket.com/albums/oo321/andyatc70/?action=view¤t=Picture645.jpg) Here she is..... waiting on the bearings for the front.....rubber and cobra pipehttp://i388.photobucket.com/albums/oo321/andyatc70/th_Picture643.jpg (http://s388.photobucket.com/albums/oo321/andyatc70/?action=view¤t=Picture643.jpg) Also threw a carb kit into the Big Red tonight........got it purring like a kitten. Tri zinger 3 fires and runs.......that's about all.... need parts.... busy day off work!!!!:drool::drool:
aldochina
01-04-2010, 11:25 PM
what is that motor you are dropping in? keep us posted
CRAZY70MAN
01-04-2010, 11:37 PM
Nitro 150 YX Evos motor........... had to change sprocket, grind, hammer, and weld but it fits!!!! Can't wait!!!
BAN ONE
01-05-2010, 02:37 PM
going to have it done for summit?? what did ya have to grind hammer and weld? we havnet had to much trouble getting them to fit..so far i just had to space my rear sproket out to get it inline with the front because my output shaft stuck out farther
CRAZY70MAN
01-05-2010, 07:22 PM
Had to gind quite a bit of the frame are by motor mounts, and rear bottom section of frame, motor was obviously a little longer or deeper. Had to redrill pegs as I used 110 footpegs. No place for oil cooler to mount.....was pretty tight so I fabbed a decent bracet to clear tire and forks at full turn. Tank is shimmed up a litttle and tuned up with a rubber mallet to get carb cable to clear. Fender bracket had to be ground down as tank was shimmed up so it would not line up. Waitin' on hubs at shop.....and front bearing I bought that have not came?????? Been over a week, hope to score a Cobra pipe from member here and I should be there!! May not be 100%, but hope to at least make the show....
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.