View Full Version : 350x rebuild questions
sportsfinat
12-18-2009, 09:41 PM
well i tore down the x cause it was smoking pretty bad and i am replacing all the valves, exhaust valve guides and putting a new piston in it. my question is that my new exhaust valve guides need reamed. i looked and a reamer using the honda part number is 80 bucks and i dont really want to spend that much money for something i may never use again. so any input on where i can get one or if someone has one i can buy or anything helpful would be greatly appreciated
Dirtcrasher
12-18-2009, 10:11 PM
I would just but a metric reamer. BUT, you need to know the exact size it should be......
I imagine thats a pretty good fit, maybe only .005mm or .0025mm?? guessing here..... (in other words, not allot of clearance) over the stem diameter. I'd call a shop that does valves and ask some questions.
Reamers cost under 20$ MSC sells them............
sportsfinat
12-18-2009, 10:16 PM
its 5.5mm reamer and i beleive its .002 clearance but ill have to look it up again
Dirtcrasher
12-19-2009, 01:20 AM
Just an example:
http://www1.mscdirect.com/CGI/GSDRVSM?PACACHE=000000120516658
I like spiral cut reamers, they cut smoother. It will be your job to ream it thru the guide in line.......
There are carbide reamers, adjustable reamers, you name it - it's in MSC or other suppliers. I wonder if the Honda tool has something to help it self center or something?? I'm sure those guides are hard as rocks :D
Carbide - http://www1.mscdirect.com/CGI/GSDRVSM?PACACHE=000000120516704
In case you haven't worked with the stuff, carbide breaks very easy. I'd want to set it up in my mill, get it rippin and lube that puppy up......
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.