need tool for 185s can you help?

[runaway]

hello
i need to change my ignition coil and cant get the magneto off. where can i buy this tool cheap. i just bought the coil off ebay and want to have the trike ready by the time it gets here. thanks

[seadoo650]

Motion pro has it and also through ebay.
http://www.motionpro.com/motorcycle/partno/08-0026
http://cgi.ebay.com/ebaymotors/1980-ATC-185-Flywheel-Puller-ATC185_W0QQitemZ270446237064QQcmdZViewItemQQptZMot ors_ATV_Parts_Accessories?hash=item3ef7da1588

[85Tecate]

Make your own for alot cheaper, thats what i do.

[rdlsz24]

Does your flywheel have where you can thread 3 little bolts in and use a harmonic balancer puller, or is the center hole threaded?

Rob

[85Tecate]

Does your flywheel have where you can thread 3 little bolts in and use a harmonic balancer puller, or is the center hole threaded?

Rob

Should be the harmonic balancer style. Mine were. I cant remember the thread size i think it was a 6mmx1.25 for the 3 bolts you will need to double up on washers probably or the bolts will pull through the puller. Also make sure NOT to thread them in very far or you will take out your lighting coil and/or the ignition coil. I did that once!

[3wheelrider]

i think you meant stator coil. anyway,- i recommend you use that motion pro tool (preferrably)or similar type. remember it has (fine)reverse thread. thread on by hand to the left on the outer part that threads into flywheel. ive used the steering wheel/harmonic balance puller type but dont recommend it. -also,i still prefer an old used original stator versus the aftermarket ones they sell now. is there any good ones made now anybody?

[AutoXer]

i used the rear axle but mine had ben off before... that tool makes the job a breeze

[85Tecate]

i think you meant stator coil. anyway,- i recommend you use that motion pro tool (preferrably)or similar type. remember it has (fine)reverse thread. thread on by hand to the left on the outer part that threads into flywheel. ive used the steering wheel/harmonic balance puller type but dont recommend it. -also,i still prefer an old used original stator versus the aftermarket ones they sell now. is there any good ones made now anybody?

No i meant ignition coil...... Its called the "primary ignition coil" Its located ON the stator along with the "lighting coil".

[leevarnado]

i also say use the right tool for the job ,a flywheel puller is really cheap and may save you money in the long run.

[runaway]

hello
thanks guys i could not find that listing,hope i will be up and runnin soon.