Hopefully my last ytm 200 question..

[drkilldrmz]

Getting ready to put the top end back in tonight. Question is, the timing chain tensioner has both the front and back plastic arms on it. The Piece that the adjuster presses on is sitting where it should, and the adjuster moves it fine. The other side came up when i lifted the head off. Does this piece just get set back in there, or does it clip in somehow? It can be removed easily by lifting it currently.. Thanks. Hopefully have it running again tonight.

[eyecekold1]

I did a dx225 rebuild and the one side does just sit in, but it went in a certain way there was a slot in the bottom of the crank case it went into to hold it from moving back and forth a lot, and 2 little slots the tabs went into between the jug and head, to hold it from moving up or down. The 200 may be different but thats how the 225 was