loock at this

[snowwolf]

What do you think of this

[Dirtcrasher]

I think the pictures suk.

I think a short sentence might help us out :lol:

Is this a 300R overbore? No 7 bolts....??

Is it a coupling??

Is it a tranny/transfer case part??

Or whats up?? Stripped threads?? A really dirty finger??

[snowwolf]

im looking at the white mark above the exhaust this is a yt 175 and on the head and the dirt on the gaskit

[leevarnado]

i seen an extra 4 holes?

[old-yellow]

snowwolf it is really hard to help because your pictures are really hard to make out, what is the problem did the motor stop running or what? To me it kinda looks like melted aluminum but the pictures are hard to tell, have you tried looking through the exhaust port to see if there is scratches in the piston. I need more information to help.

[harryredtrike]

What do you think of this

i see a two stroke cylinder head and gasket,piston looks like it has been hot,melted and deformed,alot of carbon,and holes in the head 4

[BOB MARLIN]

I think I see "Waldo".

[jasonb01]

I see dead people

[the great gazoo]

I'm blind, baby. Blind.

[edog]

I see dead people

No..................I do:welcome:

[lndy650]

the gaskets only dirty where it dosent touch. as for the piston and cylinder we need closer pictures.

[snowwolf]

I wish i had a better digatil camera

[lndy650]

did it run? looks like a lot of melted aluminum on the cylinder wall.

[CRAZY70MAN]

I see a reason to buy and ride a Honda!!:w00t: :w00t: lol Just kiddin'. it is hard to see pics, really....... just messin' around..maybe:lock:

[lndy650]

lots of useless posts on this thread... some threads you have to laugh at but this guy is just asking for opinions. snowwolf good luck with the rebuild...

[daniel_250r]

well his pics arent exaclty helpful and what do i think of that? you own a horrible digital camera, i can kind of make out a melted piston and your question is extremly vague theres my 2 cents

[old-yellow]

Snowwolf I was just on .org and I noticed that you posted this same thread over there with pictures and I was looking at those pictures and it looks like chunks of piston ring or piston skirt are stuck in the cylinder dome so I think you need to pull the motor apart and make sure there is no metal shavings in the bottom end that will tear up the crankshaft bearings and your going to have to get the cylinder bored and a new Wiseco piston for it.

Here's a link to get cheap Wiseco piston's.
http://www.mfgsupply.com/ATV.html/mv_session_id=kdwSK5Sn

[lndy650]

well his pics arent exaclty helpful and what do i think of that? you own a horrible digital camera, i can kind of make out a melted piston and your question is extremly vague theres my 2 cents
well not everybody is going to spend 200$ on a camera if you cant make much out in the pics then go post on something you can see

[old-yellow]

Snowwolf are you running premix or using the stock oil injection?

[snowwolf]

I use premix 32 to1