4 X 130 bolt pattern Any Bikes Out There With These ?

[HONDALUVR]

Ok, so I got the FL350 Odyssey out the other day and messed around with it a bit ... I need some rear rims bad !!! Anyone on here know of a trike or 4-wheeler with a 4 X 130 bolt pattern ? It needs to be a 9" or 10" rim preferably ... That way I can use my stock Odyssey hubs ...

[MonroeMike]

This might help.

http://www.mud-throwers.com/atv_wheel_chart

[freaksfix]

Alot of older Honda trikes had the 4 on 130, but most where 2 piece rims.. Some Suzuki's had the 4 on 130 also...


If you dont come up with anything let me know, ive got a nice low hour set of AMS alum 9" rims that has the 4 on 130 pattern, that id let go..

[nd4speed]

Yes 85-86 Suzuki LT250R and also probably all LT230S. I use 4/130 on my Tecate and have Douglas dual pattern 4/130 4/110 rims

[125Mule]

easiest way my buddy found for his fl250 was to just swap out the spindles for some differant ones. if i remember right he uses 250r spindles to change his bolt pattern for bigger selection of rims to use. he said the rear axle is the same as a 250r as well. but like i said he's got a fl250 not a fl350, not sure if you've got the same axle with full suspension.

[HONDALUVR]

I bolted 200x hubs to the odyssey and the rims rubbed when I tightend the hub bolt down ... The odyssey hubs are tapered on the back side and go up into a housing . the 200x hubs when into the housing ok .. but I guess they went too far . Think I could use a washer the correct thickness to keep the 200x rims from rubbing ? I also have some 400ex 9 inch rims ... to use ... but the hub thing has me worried.

[125Mule]

oops i said spindles. : P lol

what about just trimming them down a little? wouldn't blame ya if ya didn't want to cut/grind on them though.