Putting a new head on need some help

[inv3ctiv3]

So I got the new cylinder head/rocker head for my '85 200x and am going to put it on this weekend but what should I use to seal the rocker head to the cylinder head? I don't think there is a gasket for it....Gasket sealer? And if so what kind?

[Russell 350X]

I've seen guys use the red or blue RTV with good results, but there is a certain one that is recommened that I can't remember the name....someone will chime in.

[The Goat]

DO NOT OVER DO IT!!!!!


too many people slather that stuff on....seal an oil passage and consider that top end toast.

Either of the above will work. I bought a copper based one from the local auto store.

[AutoXer]

DO NOT OVER DO IT!!!!!


too many people slather that stuff on....seal an oil passage and consider that top end toast.

Either of the above will work. I bought a copper based one from the local auto store.

+1 on that . put your sealer on real light then wipe almost all of it off and you should be ok

[joshco84]

you probably need what is known as gasket eliminator. It is a clear red and is made to seal two machined surfaces together without a gasket.

[fabiodriven]

I'd go with 3 bond. That stuff is the bees knees.

[joshco84]

i think three bond, and honda bond ( i think thats the name) are the same thing as eliminator. If they are, you may be able to get regular eliminator cheaper, not sure though.

[daniel_250r]

i have yet to use this stuff but i bought it and its suggested for valve covers http://www.permatex.com/products/Automotive/automotive_gasketing/gasket_sealants/auto_Permatex_High_Tack_Gasket_Sealant.htm