atc90 carburetor wont fit

[tito13]

Ok here,s the deal i got my carburetor today from ebay whoooo hoooo, but it wont fit, the two screws that bolt on to the intake are not wide enough so the two screws wont fit the two holes on the intake (by a little bit) also even if they did fit the carburetor doesn't fit right clearance issues too , im sure this is a atc90 carburetor because thats what they said also another member from here pointed it out to me anyways it wont fit , any chance my atc90 might have a 110 intake? how would i know that? any suggestions? thanks

[shortline10]

I just looked at one of your old threads to see what manifold you have , its an aftermarket manifold for a mikuni so a stock carb wont work . your going to have to find a stock 90/110 intake and you should be able to bolt on the new carb just fine and the angle and fitment will be correct .

[Macs]

Tito, have you had any more luck with this? I am sure i have a stock intake laying or maybe an aftermarket one. I will swap you.

[tito13]

will i have to change my throttle too because it has a handle bar throttle the kind you twist with your hand?

[harryredtrike]

no the twist throttle will work,your good on that.

[tito13]

ok thanks for the advice