Activity Stream

Hope this helps, oh and make sure the carb isnt pulling in air through the oil pump line inlet on carb it needs to be blocked off if oil injection...

I had a Yamaha big wheel 200 that would do the same. Mine ended up being the stator and I believe it’s a common problem with Yamahas. I would swap...

i was looking at the two connector cdi from the moto4 200, which is the exact same engine....

Appreciate it thanks. Sent from my iPhone using Tapatalk

I will tonight in like 4-5 hrs

Hey shep can you send me a picture of the choke plunger? I think it’s too short and it’s staying open the whole time. Sent from my iPhone using...

At least you got it running. That's a lil bit of a load off.

You can't mix and match CDIs. The ignition timing has to be correct for the engine and the CDI controls that. Incorrect ignition timing can damage an...

Since I fixed everything at once-I never isolated the issue. Could have been 3 bad CDIs that worked but then didn't? Engine wasn't grounded? ...

Try a new coil.

No extra cdi but I did drop to a 168m 52p and it seemed to cleaned up quite a bit. Dropped to a 50 and it was a bit lean so brought it back up to 52....

Did the banshee shocks fit on perfectly or was fabrication needed

I could be wrong but pretty sure OP just put on a known good working CDI and it just works. I suspect that means the other ones he had issues with...

Is there an obvious bad part in this? What fixed it?

Some of those lift kits look pretty simple and inexpensive. That'd be a nice addition to a used AWD mini, even a RWD. Just enough lift to make...

I know this is an older post but I think the dt seals may fit. if not you can find new old stock seals on ebay. I recently replaced the crank...

Nice, was also going to mention last I knew Mike's cdi's had issues with the 85 style stator, unless he worked out a solution on that, my guess is...

I learned a lot 350-for sure

Boy I know that you must have about been at your wit's end trying to figure this one out.

Curiosity got the cat and I gambled... I ordered a CDI from Rick's-Mike's was out of stock. It should be here in a. week. I took a known good...

I completely agree. journeysoffroad.com sells lift kits (2-3 inch) for mini vans. I feel the newer mini vans are more SUVish than VANish........

No, i have it all cleaned up. Definitely a QA05. Has me stumped aswell. Maybe a oem replacement after they updated the design but before the 86...

I would like to see if you are still selling these. I need 2 front lines for 2 of my bikes.

Thanks guys, I hopefully have a good OEM switch on it now. So, I tried to start it today-I was excited-I thought I had it figured out... I had...

To add to that, their wire quality is horrible, generally really thick insulation so it looks like ok wire, but very little copper, Very bad for...

For future reference, the cheap switches aren't necessarily bad they just may not have the wires correctly placed in the connector. It's easy to...

That's great you're enjoying the van. It could be I'm looking but it seems like I'm seeing more minivans on the road. My take is more people are...